Rush MH-3 Beam User Manual download pdf (Page 18)

18 MH 3 Beam user manual

On if DMX on

To enable or disable the lamp being turned on automatically if a DMX signal is

present:

1. Select LAMP SETTINGS and press the ENTER button to confirm.

2. Use the DOWN and UP buttons to select ON IF DMX ON and press the

ENTER button to confirm.

3. Use the DOWN and UP buttons to select NO or YES.

4. Press the ENTER button to confirm (or, to return to the higher level of the

menu structure without any change press the MENU button).

Off if DMX off

To enable or disable the lamp being turned off automatically if a DMX signal is

not present:

1. Select LAMP SETTINGS and press the ENTER button to confirm.

2. Use the DOWN and UP buttons to select OFF IF DMX OFF and press the

ENTER button to confirm.

3. Use the DOWN and UP buttons to select NO or YES.

4. Press the ENTER button to confirm (or, to return to the higher level of the

menu structure without any change press the MENU button).

Ignition delay

An ignition delay of 0 to 255 seconds can be set, so that there is a delay

between power on and lamp on:

1. Select LAMP SETTINGS and press the ENTER button to confirm.

2. Use the DOWN and UP buttons to select IGNITION DELAY and press the

ENTER button to confirm.

3. Use the DOWN and UP buttons to specify a duration.

4. Press the ENTER button to confirm (or, to return to the higher level of the

menu structure without any change press the MENU button).

Low power delay

A low power delay is where the lamp runs at half power for a period before

shutting off when a lamp off command is issued:

1. Select LAMP SETTINGS and press the ENTER button to confirm.

2. Use the DOWN and UP buttons to select LOW POWER DELAY and press

the ENTER button to confirm.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

No comments

Rush MH-3 Beam User Manual Page 18